|
INTRODUCING
ICEWAVE
Imagine
rapid & drug-free pain relief.
Now imagine
it’s yours with LifeWave.
Our exclusive non-transdermal patch system
utilizes new technology to gently stimulate
acupuncture points – literally improving the
flow of energy in the body for improvement of
pain and discomfort – within minutes.
Below is
an example of where to place Icewave patches for
pain relief.
The Tan patch is placed over where there is the
most intense pain.
*******
PLACEMENTS FOR
WHOLE BODY PAIN RELIEF
 |
STEP 1 Place a TAN IceWave patch directly on the
point where you have the most pain.
|
 |
STEP 2
Now move the WHITE patch ABOVE the pain. If
pain has not been reduced in 10 seconds go to
next step.
|
 |
STEP 3 Move the WHITE patch to the 3 O’Clock
position. If pain has not been reduced in 10
seconds go to next step.
|
 |
STEP 4 Then move the WHITE patch to the 6 O’Clock
position. If pain has not been reduced in 10
seconds go to next step.
|
 |
STEP 5 Next, move the WHITE patch to the 9 O’Clock
position. If pain has not been reduced in 10
seconds go to next step.
|
 |
STEP 6 Finally, move the WHITE patch parallel to the
TAN patch. If pain has not been reduced in 10
seconds see below.
|
Experience has shown that very often one set
of IceWave patches placed on the
bottom of the feet will relieve pain throughout
the body. We have also found that
when a second set of patches is necessary, that
at least one of the other
acupuncture points in this section will work
extremely well in relieving pain.
Some Common Questions About Icewave.
Q: Why haven’t I experienced pain
relief?
A: The most common reason is dehydration.
Drink one or two glasses of water
and then wait 20-30 minutes to apply patches.
Another common reason is that
you have placed the patches in the wrong
locations. Using IceWave patches for
pain control requires practice, follow the Clock
Method instructions. If you
have followed the directions and have not
experienced pain relief, try placing
the patches on the bottom of the feet; (Kidney
1)
Q: When should you use the White patch on
the pain instead of the Tan
patch?
A: Place the WHITE patch on the pain only
AFTER you have tried placing the TAN
patch on the pain with the Clock Method. Now,
follow the Clock Method
instructions, using the WHITE patch on the pain
in place of the TAN patch.
Q: How do you apply the patches for whole
body pain?
A: Place the WHITE patch on the bottom of
the RIGHT foot and the TAN patch on
the bottom of the LEFT foot; (Kidney-1).
Q: Where do I place the patches for
knee pain?
A: Place the TAN patch on the inside of
the knee, and the WHITE patch on the
outside of the knee.
|
